| Learning to get enough height to start grinding and | | | | the plywood into the 2"x4"x3' boards. |
| stalling can be a real challenge for the beginning BMX | | | | The finishing nails are nailed into the board about |
| biker. Here is something that can be built and used to | | | | ½" to ¾" The nails provide a place for the plastic |
| get the heights needed. The best part about it that it | | | | pipe to hang. You can put the nails 1" apart going up |
| is cheap and easy to build. Materials can found at | | | | on each side. |
| your local lumber/hardware store. The materials | | | | Using the Bunny Hop Trainer. |
| needed are as follows; | | | | Set the trainer in the middle of the area you are |
| 2-2"x4"x3'board | | | | going practice. Set the pipe on the lowest nail to get |
| 1-1/2"x8' piece of hard plastic water pipe. | | | | use to it. Start from the opposite side where the |
| 20-2" finish nails. | | | | pipe hangs and ride towards the pipe and hop over it. |
| 1-3/4"x1'x4' plywood | | | | If you hit the pipe it will simply fall off the hanger. |
| 4-3"deck screws | | | | When you clear the pipe with ease raise it another 1". |
| With the materials assemble as the diagram illustrates. | | | | You will find after using the Bunny Hop Trainer your |
| "You can see the detailed picture at under articles | | | | grinding and stalls will be easier at the Skate Park or |
| page". | | | | street riding. You can amaze your BMX and |
| The 3" deck screws come up from the bottom of | | | | skateboarding hombres with your new learned skills. |